Radiant Floor Heating System Repair in Burton, TX
A radiant floor heating system that is acting up rarely fixes itself. Call us for radiant floor heating system repair in Burton, TX and a technician will diagnose it, quote the fix before starting and use parts matched to your model.
- Upfront quote before work
- 90-day parts & labor warranty
- Parts matched to your model
- Same-day service when available
How we repair your Radiant Floor Heating System
A radiant floor heating system warms rooms from the floor up using hot water tubing or electric heating cables installed under the floor surface. A radiant floor heating system relies on a heat source, safety controls such as limit switches and flame sensors, blowers or circulator pumps, and a thermostat. A technician checks the ignition and safety sequence, airflow or water flow, and electrical controls.
Radiant Floor Heating System repair at a glance
- Typical repair cost$150–$650
- Typical service life20–35 years
- Warranty on repairs90 days parts & labor
- QuoteUpfront, before work
- Same-day visitsWhen available
Common Radiant Floor Heating System problems we fix
What usually causes each symptom, and what our technician checks to confirm it.
Electric floor heat not working
- Likely causes
- A tripped GFCI in the thermostat, a failed floor sensor, or a damaged heating cable.
- What our technician checks
- The GFCI and thermostat are tested, sensor resistance is checked, and cable resistance and insulation are measured.
Pressure dropping in hydronic system
- Likely causes
- A leaking manifold fitting, a failed expansion tank, or a relief valve discharging.
- What our technician checks
- Manifold connections are inspected and the system is pressure tested.
One zone not heating
- Likely causes
- A failed zone valve or actuator, a bad zone thermostat, or air locked in that loop.
- What our technician checks
- The technician tests the thermostat call, actuator operation and loop flow at the manifold.
Cold spots in the floor
- Likely causes
- Air in a loop, a balancing valve set too low, or a damaged tube or cable section.
- What our technician checks
- Loops are balanced and purged, and an infrared camera is used to locate cold areas.
Floor takes very long to warm up
- Likely causes
- Low supply water temperature, a failed mixing valve, or a circulator that is too weak.
- What our technician checks
- Supply and return temperatures are measured and the mixing valve and circulator are tested.
Floor too hot
- Likely causes
- A stuck mixing valve sending full boiler temperature to the floor, or a failed floor sensor.
- What our technician checks
- Mixing valve operation and floor sensor readings are checked against setpoints.
Quick checks you can do safely
- Check the zone thermostat setting and batteries.
- Press the test and reset button on an electric floor thermostat.
- Look at the manifold pressure gauge on hydronic systems.
- Confirm the boiler or water heater feeding the system is running.
- Allow several hours for the floor to respond after changing the setting.
Safety first: Never drill or nail into a heated floor without locating the tubing or cable, and electric systems must stay GFCI protected.
Still not working?
Call and describe what you see and hear, plus any error code. It helps the technician bring the right parts on the first visit.
(844) 442-1999Seeing a code? Try our error code lookup or troubleshooting wizard.
Our 5-step radiant floor heating system repair process
- Call or book onlineTell us the appliance, brand and what it is doing. We confirm a visit window that works for you.
- DiagnosisThe technician inspects and tests the radiant floor heating system to find the actual cause, not just the symptom.
- Upfront quoteYou get a clear price before any work starts. No surprise charges.
- RepairWe fix it with parts matched to your model, often on the same visit when the part is on the truck.
- Test and warrantyWe test the unit under normal operation, clean up and back the repair with a 90-day parts-and-labor warranty.
Radiant Floor Heating System repair cost and lifespan
National ballpark estimates. Your exact price depends on the part and labor, and you get it upfront after diagnosis. On the fence? Try the repair vs replace calculator.
Parts we replace most often
- Zone valve actuator
- Mixing valve
- Circulator pump
- Floor temperature sensor
- Manifold flow meter
- Floor heating thermostat
- Expansion tank
We match every part to your model and serial number.
Keep your Radiant Floor Heating System running longer
- Test GFCI protection on electric systems as directed.
- Have the boiler or heat source serviced yearly.
- Purge air from loops if any zone heats unevenly.
- Avoid thick rugs that insulate and overheat the floor.
- Check system pressure monthly in heating season.
Build a maintenance plan
Create a printable monthly, quarterly and yearly checklist for every appliance in your home.
Open the schedule generatorRadiant Floor Heating System repair in Burton, TX
Hot summers and sudden cold snaps in Texas put refrigerators, freezers and ice makers in Burton under heavy load.
We provide radiant floor heating system repair throughout Burton, including ZIP code 77835, and in nearby Brenham, Somerville and Giddings.
In coastal parts of Texas, salt air speeds up corrosion on coils, burners, fasteners and electrical connections, especially on equipment installed outdoors.
Radiant Floor Heating System brands we repair
Frequently Asked Questions
How much does radiant floor heating system repair cost in Burton, TX?
Most radiant floor heating system repairs fall roughly between $150 and $650, depending on the part and labor involved. That is a national ballpark estimate; you get an exact quote after diagnosis and before any work starts.
Can you repair my radiant floor heating system the same day?
Often, yes. Call (844) 442-1999 early in the day and we will try to schedule a same-day visit. Same-day service depends on technician availability and whether the part is in stock.
Is the repair guaranteed?
Yes. Completed repairs are covered by a 90-day parts-and-labor warranty. If the same problem comes back in that time, we come back and fix it.
Which brands do you service?
We work on all major brands, including Nuheat, SunTouch, Uponor and Warmboard.
Should I repair or replace my radiant floor heating system?
A typical radiant floor heating system lasts about 20 to 35 years. If yours is well within that range and the repair costs less than half the price of a new one, repair is usually the better value. Our technician will tell you honestly if replacement makes more sense.
Other heating equipment repairs
- Heat Pump Repair
- Furnace Repair
- Boiler Repair
- Infrared Heater Repair
- Baseboard Heater Repair
- Wall Heater Repair
- Geothermal Heat Pump Repair
- Patio Heater Repair
- Ductless Mini-Split Heat Pump Repair
- Space Heater Repair
More repair services
Get your radiant floor heating system fixed in Burton
Upfront quote before work starts · Parts matched to your model · 90-day warranty